Quick Start Section
Quick Start documents to help you get up and running with your PTZOptics camera!
Setting up the cameras with a connection to the router on site. Use this setup if your cameras are connected to your onsite router. If you plan on se...
Wed, 11 May, 2022 at 11:51 AM
There are multiple ways to get the cameras on the network. This guide goes over using the Upgrade tool to find the cameras and change their IP address to fi...
Wed, 8 Jun, 2022 at 4:55 PM
The PTZOptics cameras have many different ways of working within OBS. You can set them to pull in video over the network using RTSP or NDI, using HDMI...
Fri, 4 Nov, 2022 at 12:09 PM
This article will go over how to install the grounding pin to PT-JOY-G3 units, how to make sure the joysticks are properly grounded, and issues that will be...
Wed, 11 May, 2022 at 12:23 PM
Please refer to the attached sheet for setting up a PTZOptics NDI®|HX camera.
Tue, 14 Jun, 2022 at 11:06 AM
Please note: these steps are for cameras that are being upgraded to allow for NDI video and not the NDI model cameras. These steps would not apply to any ca...
Fri, 23 Jul, 2021 at 5:08 PM
Confirm your camera model. Using the camera's serial number is the best way to figure out what model camera you have and the article HERE can help ...
Thu, 30 Jun, 2022 at 10:29 AM
The PTZOptics SDI models have (3) simultaneous outputs: SDI, HDMI, and the Ethernet output. To use the SDI or HDMI output you will need to make sure the res...
Mon, 7 Feb, 2022 at 2:49 PM
This article will cover bringing the RTSP feed of the camera into some commonly used Video Mixing software (OBS, vMix, and Wirecast). Please Note: In or...
Fri, 24 Sep, 2021 at 12:24 PM