General
General questions about the PTZoptics camera line.
The power adapter for the PTZ optics camera is a EIAJ-04-Philmore255 Out side Diameter - 5.50mm Inside Diameter - 3.30mm Shaft - 9.90mm Center Pin ...
Wed, 21 Apr, 2021 at 5:40 PM
All video outputs for the PTZOptics 12X-USB, 12X-SDI, 20X-SDI and 20X-USB are all simultaneous EXCEPT for the composite video output. Since a dial is u...
Mon, 3 Oct, 2016 at 10:44 AM
No, the cameras are not HDCP compliant.
Tue, 14 Jul, 2015 at 9:17 AM
You technically can't change the "Home position" but you can set up the camera to default to another location right after it does its start up...
Mon, 29 Oct, 2018 at 9:15 AM
The CVBS port on the back of your PTZ Optics camera should allow you to get a 640x480 video feed into any composite video device. Please note: The CV...
Thu, 22 Apr, 2021 at 4:00 PM
When you are using the CVBS port form your PTZOptics camera, it does fit a 16:9 image into a 4:3 space, so you end up with a slightly "squished" i...
Thu, 22 Apr, 2021 at 4:28 PM
If you need to reset the camera to original factory default IP address please use the included IR remote and press each key mentioned in succession: * ...
Mon, 15 Aug, 2022 at 9:35 AM
Updated 2-24-20 - The PTZOptics camera line has 16 different selectable resolutions. These are changeable using the rotary dial on the back of the camera. ...
Thu, 22 Apr, 2021 at 4:35 PM
The PTZOptics cameras have multiple simultaneous outputs and setting the resolution can be different for each of them. Streaming: When pulling eit...
Thu, 22 Apr, 2021 at 5:28 PM
The camera latency can be based on a number of factors, but typically a Broadcast Quality Standard is <60ms of latency. At around 120ms is where this can...
Fri, 23 Apr, 2021 at 12:53 PM